Page 3 of 3
Re: Digger project
Posted: Wed May 01, 2019 2:56 am
by yaksplat
That looks great!
The toughest part for me was getting the tray all set to slide into the cabinet. There are notches on each of the four corners to slide the tray in. Once the front corners engage the tray, it's held up and solid. My prize ramp was installed after the tray and just has screws holding everything together so it comes apart easily.
Re: Digger project
Posted: Thu May 02, 2019 8:36 am
by ddstoys
Here’s the almost finished product. I had to use my older mech as the Tonka one sits lower than the plans where designed for
Re: Digger project
Posted: Thu May 09, 2019 9:34 am
by ddstoys
And then there were two.
Re: Digger project
Posted: Sat May 11, 2019 3:51 am
by yaksplat
Just like magic?
Re: Digger project
Posted: Sun May 12, 2019 10:48 am
by ddstoys
Yep, and all thanks to you - without your posts I probably wouldn’t have touched these.
I’m just about to send you something for your
Re: Digger project
Posted: Sat May 23, 2020 6:07 pm
by rhinomods
Fantastic Job! I am glad to see the progress!! I had been lurking at topic on the forum for a couple years, and finally made an account!
Re: Digger project
Posted: Fri Oct 02, 2020 4:35 pm
by hemiroid
Great Job!
I'm a late arriver but enjoyed reading on your progress...
Did I miss it or did you post the plans somewhere for the cabinet you built?
Thank you...
Re: Digger project
Posted: Thu Dec 10, 2020 9:52 pm
by rob1986
ddstoys wrote: ↑Sat Dec 08, 2018 4:24 am
I have a couple of these mechs I can probably help you out.
Hi. Do you still have any of the old ‘Digger’ mechs. If so, are any of them for sale? Many thanks, Rob.
Re: Digger project
Posted: Wed Mar 31, 2021 10:10 pm
by ddstoys
Nah mate, built cabinets for both of them.
