Graphics, flyers, instructions and other materials.
9 posts • Page 1 of 1
I thank you very much for this image! However, I am puzzled about one thing. If the image as given is printed on A3 paper, each slot machine symbol will apparently take up 3.5 cm exactly. That implies the reels have a diameter of 8.772319... inches (and in metric, the reciprocal of pi being involved, it won't be a round number either). What is the radius of the reels on this machine?
Do you need this because you plan to print or are just curious. I do not have a reel tin in front of me, but it maybe slightly smaller as reel strips are just over 25”. There is always on overlap on most strips which you need to exclude
I do lots of replacement reel strips for people (30 sets last year) .. If your copying existing sets like Tom has its quite easy to get the spacing right,if your building sets from scratch its not. This is because the symbols themselves are all different sizes. What I do is measure the visual length of the full strip,divide it by 20 to get a blank rectangle. Then I fit each of the symbols into the centre of a rectangle and save them (there are of course usually only 6 or 7) then I create a blank reel strip of the correct length and width ,then all I need to do is drop the correct master symbol onto the blank strip one after another in the correct order to create any reel strip,once I have the 6 masters its takes about 5 mins to create each strip, and once I have, lets say the set of Sega masters on file I can create any Sega set of three strips in about 25 mins, if you print on vinyl the result is near perfect
I have started to enjoy using Paintshop Pro now and am able to quickly make or modify awards and strips and restore them as required. I need a large guillotine and A3 printer now. I have started making strips slightly wider now than actual to compensate for damage and loss and then fill and trim.
Better a cutter than a guillotine - more accurate and a better cut. A3 printers can be expensive. Many printers now handle "legal" size (11.5" x 8.5") which will do 90% of what you need but not allwin backflashes. Also a good idea to spray your finished work with ink jet fixer to protect from UV fading.
Users browsing this forum: No registered users and 1 guest