Advice and guidance on repair and restoration techniques.
User avatar
scottie
Posts: 276
Joined: Tue Dec 07, 2010 7:27 pm
Location: Canada
Contact:

Rust off with wire wheel

Postby scottie » Tue Sep 26, 2017 10:26 am

Just goes to show you, no matter how must rust is on a machine, anything is possible.
Works like a charm, just have to install it in the machine and I'm done and on to the next one, thanks to the wire wheel on my grinder.
Scottie
16943_160922-093701.jpg
Before
20170925_110356a.jpg
After
20170925_110428a.jpg
After
20170925_110631a.jpg
After

widget2k4
Posts: 1352
Joined: Tue Aug 27, 2013 8:32 am
Contact:

Re: Rust off with wire wheel

Postby widget2k4 » Tue Sep 26, 2017 12:35 pm

Nice job mate !!THUMBSX2!!

User avatar
scottie
Posts: 276
Joined: Tue Dec 07, 2010 7:27 pm
Location: Canada
Contact:

Re: Rust off with wire wheel

Postby scottie » Thu Sep 28, 2017 3:21 pm

thank you Widget2k4

well i think im all done,just have to bum a few cig off someone and test it out that the cig drop properly.
what a day yesterday, i was mounting the cig vender in the allwin not a big deal at all,but then i had to connect the vending part to the knob linkage ...so when you turn the knob you get your cig.
very long story short it didnt go well,pick up some flat stock,came home,measured,cut,bend ,drill holes,and tap some threads..dropped one bolt on the floor of the garage never did find that one,also dropped a nut which i found this morning ,broke, well i lost track how many but somewhere around 5 or 6 1/16 inch drill bits..and broke 2 taps ...bad day in the garage and the worse part ...the part i made didnt work,so i cleaned up, put all the tools away and made another piece just out of tin ,again just to see if i was going about it the wrong way
crazie thing is the thin tin work fine ,doesnt look as nice but ill leave it for now :dammit:

scottie

widget2k4
Posts: 1352
Joined: Tue Aug 27, 2013 8:32 am
Contact:

Re: Rust off with wire wheel

Postby widget2k4 » Thu Sep 28, 2017 3:44 pm

Haha that's the world of slots mate


Who is online

Users browsing this forum: No registered users and 1 guest