Page 2 of 4

Re: C.M. Schwarz Tura

Posted: Wed Jun 26, 2019 8:11 pm
by badpenny
It's always likely mastereddy69 that if your machine hasn't got a vendor yet cast plates over the window, there's every likelihood it came from the factory that way.

The same could apply with the skill linkages. You may be trying to restore it to something it never was.
We sometimes get posts on here asking what the authentic colours were for bandits.
In the 60s I remember my Uncle taking delivery of new Sega bandits in primer. They were cheaper and many establishments wanted to paint them in their own club colours anyway.

BP :didact:

Re: C.M. Schwarz Tura

Posted: Thu Jun 27, 2019 2:58 pm
by mastereddy69
It has no cast plates over the windows so I think it should have had one.

I came across this one on ebay https://www.ebay.de/itm/Heros-Mills-ein ... Swf5BbGS-k

but to buy it only for the vendor????

Re: C.M. Schwarz Tura

Posted: Thu Jun 27, 2019 7:04 pm
by badpenny
I asked you if the vendor roll is there, because the knob on the right must be attached to something.

BP !PUZZLED!

Re: C.M. Schwarz Tura

Posted: Thu Jun 27, 2019 8:04 pm
by mastereddy69
Sorry badpenny I misunderstood. Yes, the knob is there but, when I take the front casting off, there is no vendor. The knob goes from one side to the other, but nothing attached to it.

Re: C.M. Schwarz Tura

Posted: Fri Jun 28, 2019 1:39 pm
by badpenny
That's a blighter, if the roll dispenser had been intact it wouldn't have taken much to get that working.

Re: C.M. Schwarz Tura

Posted: Sat Jun 29, 2019 6:35 pm
by mastereddy69
Does anyone know what that little glass window is on the top left of the front of the machine?

Re: C.M. Schwarz Tura

Posted: Sat Jun 29, 2019 9:06 pm
by coppinpr
Window for the coin denominator? It's a bit small but looks like one. BP will know.

Re: C.M. Schwarz Tura

Posted: Sat Jun 29, 2019 11:14 pm
by badpenny
I haven't got a clue.
Every Tura Bell I've owned had it, but it lines up with nothing on the inside.

My only suggestion is they used the same castings for the other bandit they made (can't think of its name, but it's also in Dieter's book) it had no jack pot and the bottom half was all vendor. In fact if you look carefully at The Tura you'll see where the middle is cut out by hand so the jack pot has space to fit.
Anyhow what I was going to say before I wandered off for a moment, perhaps the other machine had a coin view window that lined up. Just not on the Tura Bell.

BP :!?!:

Re: C.M. Schwarz Tura

Posted: Fri Jul 05, 2019 1:25 pm
by treefrog
I have just noticed that the well known dealer in Belgium Werner Paredis has a picture of a trailer load of parts and machines he bought a while back on his Facebook page and is loaded with Turas......maybe worth pinging him an email.....he is on the site as Coinopbelgium, but is not a contributor sadly .... :#:



http://www.coinopeurope.com/en/enhome/

Re: C.M. Schwarz Tura

Posted: Fri Jul 05, 2019 8:38 pm
by mastereddy69
Thank you treefrog **xXx** , for sure I will send him an email. Maybe he can help me out with some parts I need.