Tell us a bit about yourself.
jothebulb
Posts: 6
Joined: Tue Aug 13, 2019 1:34 pm

New forum member, plus Arizona machine

Postby jothebulb » Tue Aug 13, 2019 1:56 pm

Hi,

I’d like to introduce myself (I’m Jon) & the machine I found a while ago in a local vintage shop near where I live in Surrey

From reading around on the forums here & some searching online, I believe I have an English-market model of a Wulff wall-mounted machine. The case is pretty battered, but crucially (for me) the mechanism just about works: it was sold to me as not working, but I discovered the last owner had tried using it with modern 2p pieces & I believe it should correctly be used with old pre-decimal pennies. Once I had cleared the jam, the system runs.

I’d love to be directed to any resources or knowledgeable people to help me restore this machine (for example, bent nails have been used to replace some of the pins inside the mechanism) both mechanically & cosmetically - as you can see from this image, the poor thing hasn’t been well looked after, but is still solid.

Jon.
IMG_4933a.jpg
Arizona machine

User avatar
badpenny
Forum Moderator
Posts: 5992
Joined: Thu May 05, 2005 12:41 pm
Location: East Midlands
Contact:

Re: New forum member, plus Arizona machine

Postby badpenny » Tue Aug 13, 2019 2:04 pm

Hi and welcome on board.

Nice machine I've had a couple myself.
To help the mech, use a degreaser or acetone to remove any grease it may have been lathered in, and use a light oil on anything that moves except the coin slides.
You will see oiling holes on a lot of the spindles, and the bearings on the back of the clock.
Post some photos of the bits you have doubts about and we can advise better.

BP :cool:

jothebulb
Posts: 6
Joined: Tue Aug 13, 2019 1:34 pm

Re: New forum member, plus Arizona machine

Postby jothebulb » Tue Aug 13, 2019 2:17 pm

Dear BP,

Thanks for the welcome & the advice - all useful for someone who is really just starting out. I’ve also read the basic tips & tricks section.

If I want to post images of the mechanism I could do with help with, which is the best place to put them on the forum?

Jon.

User avatar
pennymachines
Site Admin
Posts: 4709
Joined: Wed Nov 06, 2002 12:12 am
Location: The Black Country
Contact:

Re: New forum member, plus Arizona machine

Postby pennymachines » Tue Aug 13, 2019 3:16 pm

Welcome Jon!
jothebulb wrote:
Tue Aug 13, 2019 2:17 pm
If I want to post images of the mechanism I could do with help with, which is the best place to put them on the forum?
Let's start a new topic.


Who is online

Users browsing this forum: No registered users and 2 guests