Page 1 of 1

Bryans Elevenses

Posted: Mon Jul 23, 2018 11:59 am
by mei-mei
Hi guys, would anyone out there have a spare 1d chute and the tube drop for a Bryans Elevenses machine? The one I have here has been converted to a 1p mechanism and I am trying to convert it back. Pics below of the parts that I have for 1p. Thanks a bunch, Mei-mei

Re: Bryans elevenses

Posted: Mon Jul 23, 2018 12:44 pm
by bryans fan
It's hard to see from your pictures, but it looks like the coin chute has had 1 side re soldered to the narrower 1p coin size. You could de-solder it and reposition for 1D.
The coin hopper looks original 1D size packed out to be smaller. One of mine was done with newspaper and filler to make it smaller diameter.

Re: Bryans elevenses

Posted: Mon Jul 23, 2018 1:01 pm
by mei-mei
Hi, thank you Bryans Fan, I think you might be right about the coin drop, but the slide is only the width of a 1p. Woodwork is my forte, I stink at metal work. How would I remove the solder from the coin drop? Mei-mei

Re: Bryans elevenses

Posted: Mon Jul 23, 2018 1:56 pm
by bryans fan
Mech in bits.jpg

This was my coin hopper before I removed the sleeve which reduced the Diameter to 1np. I thought yours looked the same.

Gapwin mech castle top.jpg
Gapwin mech castle top.jpg (11.17 KiB) Viewed 1831 times
Normal 1D hopper


I have done some soldering and de soldering with a hand held blow lamp filled with lighter gas. I will search for one online straight after posting this and put up a picture asap.

Re: Bryans elevenses

Posted: Mon Jul 23, 2018 2:00 pm
by bryans fan

Re: Bryans elevenses

Posted: Mon Jul 23, 2018 2:30 pm
by mei-mei
Appreciated thank you so much. Mei-mei