Page 1 of 1

Ball Bearings - Where can I get them from?

Posted: Sun May 02, 2010 10:37 am
by davethebirdman
Chaps

I have just purchased a "What's my Line" Allwin by Ruffler & Walker. Some of the ball bearings in the machine
are newer than others. The newer ones are slightly too large and get caught in a couple of the channels and as a result
won't then fall through the hole and trigger the payout.

Could anyone please let me know where I can get the ball bearings from and If anyone has the size of the original balls
I would be very grateful.

Thanks

Dave

Re: Ball Bearings - Where can I get them from?

Posted: Sun May 02, 2010 12:08 pm
by badpenny

Re: Ball Bearings - Where can I get them from?

Posted: Sun May 02, 2010 12:14 pm
by davethebirdman
Thank you... I knew I had seen them somewhere once before.

My computer skills are such, that I often see something ....Only once, because I never remember how to get
back there again.

Dave

Re: Ball Bearings - Where can I get them from?

Posted: Sun May 02, 2010 1:02 pm
by pennymachines
They're 14mm.

Re: Ball Bearings - Where can I get them from?

Posted: Sun May 02, 2010 3:10 pm
by davethebirdman
Thank you for the size... That makes life so much easier...

Dave