Page 1 of 1
Dog
Posted: Wed Mar 06, 2019 12:08 am
by onemoretime_
I am looking for the handle starting lever dog and pin for my Mills Operator's bell slot machine. Even a clear picture and the measurements would be helpful.
Thanks in advance
Doug.
Re: Dog
Posted: Wed Mar 06, 2019 1:38 am
by badpenny
Hi and welcome to here.
It was me who answered your query on FB and suggested you ask here. Like I said on FB, it'd be a good idea to post a photo of the side of your mech showing what you're looking at as names of parts differ around the world. Am I right in thinking you're in Americaland?
I'll point out that we normally ask established forum members to place For Sale & Wanted adverts in The Market Place section
https://pennymachines.co.uk/market/wanted/
However, you've only just arrived, so please bear it in mind for next time.
Post the photo and if it's what I think you need I have an idea where there may be some.
Regards BP
Re: Dog
Posted: Wed Mar 06, 2019 2:30 am
by onemoretime_
I am in Canada.
Re: Dog
Posted: Wed Mar 06, 2019 4:08 am
by moonriver
That's told you then!
Re: Dog
Posted: Wed Mar 06, 2019 12:16 pm
by badpenny
Sure am.
BP