Building a slot machine from scratch? You're not alone in your madness.
jonathans257
Posts: 31
Joined: Thu Oct 18, 2012 9:21 pm
Contact:

Latest on making parts for Cascade project

Postby jonathans257 » Wed Feb 13, 2013 2:49 am

I have been wanting to build a Cascade machine for some time and eventually got started. I wanted my machine to run on 10 pence's, so the trickiest parts to make were the coin triggers or coin acceptors. I wanted to purchase but after thinking that the parts available were for old pennies or two pence pieces I set about manufacturing some slightly bigger for a 10 pence dia. Being 24.5mm, I've made these out of 1.5mm mild steel sheet which I will have chromed. I haven't made all the parts yet but here's a few pics of parts made so far.

The second stage of the build will be the coin shooting mechanism.
20131117_153138.jpg
coin-accepters.jpg
20130219_225726.jpg
20130224_214144.jpg




Last edited by jonathans257 on Tue Nov 19, 2013 1:06 am, edited 8 times in total.

User avatar
badpenny
Forum Moderator
Posts: 6301
Joined: Thu May 05, 2005 12:41 pm
Location: East Midlands
Contact:

Re: making parts for cascade project

Postby badpenny » Wed Feb 13, 2013 9:19 am

Best of luck, keep us advised of your progress.
Bell Cascade runs on 1np not predecimal coinage

BP

User avatar
slotalot
Posts: 1841
Joined: Mon Apr 21, 2008 1:53 pm
Location: Halifax West Yorkshire
Contact:

Re: making parts for cascade project

Postby slotalot » Wed Feb 13, 2013 9:38 am

Sounds like a good project !THUMBS! best of luck with the build :D

jonathans257
Posts: 31
Joined: Thu Oct 18, 2012 9:21 pm
Contact:

Re: making parts for cascade project

Postby jonathans257 » Wed Feb 13, 2013 12:01 pm

badpenny wrote:Bell Cascade runs on 1np, not pre-decimal coinage
Ah, thanks - a penny is about 18 mm diameter so I did have to make these parts.

User avatar
badpenny
Forum Moderator
Posts: 6301
Joined: Thu May 05, 2005 12:41 pm
Location: East Midlands
Contact:

Re: making parts for cascade project

Postby badpenny » Wed Feb 13, 2013 3:01 pm

I'm not sure about that, I could have sworn they were one and a quarter inches across.

BP

vierklee
Posts: 1
Joined: Sun Nov 16, 2014 3:03 pm

Re: latest on making parts for cascade project

Postby vierklee » Sun Nov 16, 2014 4:28 pm

HI,

Have you got any pictures, drawings or further photos of your Cascade?
I want to build one myself an it would be very nice if I could get any help.

Regards
Dean


Who is online

Users browsing this forum: No registered users and 1 guest