Cutting the thick acrylic was the hardest part, I tried several ways including an acrylic scribe tool but that was too risky as you need to snap the sheet (broke the first one) in the end a coping saw was the easiest especially as there is a cut out area at the top of these panels .
I scanned the artwork and re-built it, then cut it in half and printed the two separate halves on to the vinyl, to reduce the join I printed the "2 games for 5p" disc as a separate item and stuck over most of the join. A lot of care is needed to position the sticky vinyls when applying them to the sheet but it worked out ok.
Dont know if id use the new or the old if I was keeping the machine but as Ive got three ive already sold this one , the buyer can chose the old one or the new,up to him.(as hes most likley reading this he can let me know) (I think id go with the new,the old is badly marked on the glass as well as the artwork and very faded. anyway I thought it worked out OK, Now ive got to make a new base which will mean learning how to use my new router